Use Cutting machine should try to avoid the direction of rotation of staff nearby. The material shall not be cut stretching sidewalk.
Cutting machine with explosive dust are not allowed in places.
Cutting machine on a mobile base four supporting wheels should be complete and intact, installation firm, flexible rotation. Placement should be balanced and reliable, without apparent shock at work.
Clamping device should manipulate flexible, reliable clamping. Hand wheel, screw, nuts, etc. should be intact. Screw thread may not have slippery silk, Labelling phenomenon.
Leverage should have sufficient strength and rigidity. After all the parts fitted to maintain the freedom to lift.
Lever shaft should be intact, rotating flexible and reliable. After the lock nut and lever assembly applications.
Cut the replacement piece. Must cut off the power. Cut slices newly installed equipment to meet the requirements. Do not install the quality of the cut piece. According to the installation program to install.
Cutting machine replaced after cutting pieces to try to run if there is a significant shock. Can be used after confirmation operating normally.
Operation box or switch must be in good condition and have ground fault protection.
Gearing shield must be safe and reliable. And can block the broken pieces after cutting flying debris. Baffle ends should be securely mounted on the casing. When the work is strictly prohibited removed.
The operator control handle for cutting exercise. Force should be uniform, smooth, not too much force, so as not to overload the cutting piece to crack.
After completion should be placed with the power off, clean up good health.
