1.1 To implement the principle of" safety first, prevention first ", strengthen safety management, enhance security awareness and ensure safe production, eliminate human unsafe behavior, physical insecurity state, make rules to be safe production followed, evidence-based, especially the development of the regulations .
1.2 Regulations applicable to every workshop maintenance worker positions.
2.1 Before cutting, first wear (Welding Mask, Welding Gloves, glasses), to avoid spatter wounding.
2.2 Cutters must be checked before use can normally use (such as whether the damaged power lines, cutting discs are tight because without damage, etc.).
2.3 Replacing the cutting films, first turn off the power, hanging signs, cutting discs are concentric tightening to avoid falling wounding.
2.4 Cutters must be specified in the workshop room use, and not for combustible and people are cutting.
2.5 When start, make sure the cutter rotates in correct direction.
2.6 When cutter cutting an object, the object must be clamped.
2.7 Cutting force should be smooth objects. Running, such as cutting discs damaged, stop using it immediately shall replace intact cutting discs running.
2.8 After cutting, first turn off the power, to be grinding wheel stops, then take an object, in order to avoid spinning the cut pieces wounding.
2.9 Prohibited the cutting chip sanding objects.
3.0 After cutting is completed, the cutter must be tidy and clean cutting area clean.
